Filter
Top Products
Model G0775 (Mfd. Since 11/14)
-17-
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and
seek additional training from expe-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To complete a typical sanding operation, the
operator does the following:
1. Examines workpiece to make sure it is suit-
able for sanding.
2. Adjusts table tilt if necessary and locks table
in place.
3. If necessary, inserts miter gauge in either
X-axis or Y-axis miter slots, adjusts miter
gauge to required sanding angle, and locks it
in place.
4. Puts on safety glasses and a respirator.
5. Starts machine and dust collector.
6. Holds workpiece firmly and flatly against
both table and miter gauge (if used), pushes
workpiece into or along down-spin side of
sanding disc, and moves it to different loca-
tions to wear sandpaper evenly and prevent
it from overheating.
7. Stops machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.