Filter
Top Products
Model G0775 (Mfd. Since 11/14)
-19-
Figure 13. Example of sanding with table tilted.
Note: You can use the included radius sanding
attachment to sand round workpieces. Insert the
sanding attachment into the Y-axis. Mark the cen-
ter of the workpiece with an awl or center punch.
Place the center mark over the pivot point of the
sanding attachment. Spin the workpiece clock-
wise against the down-spin side of the rotating
disc.
Note: To perform sanding on compound-angle
cuts, tilt the table and rotate the miter gauge to the
appropriate angles.
Note: To prevent burning the workpiece and over-
loading the sanding disc, move the workpiece
slowly back and forth from the left side of the
sanding disc to the center and do not use exces-
sive pressure.
6. With moderate pressure, push workpiece into
down-spin side of rotating disc. See Figures
10–13 below for examples of disc sanding.
Figure 10. Example of Y-axis sanding.
Figure 11. Example of X-axis sanding.
Figure 12. Example of angle sanding.