Filter
Top Products
Model G0779 (Mfd. Since 09/14)
-13-
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Small Item Inventory (Figure 5) Qty
A. Hex Wrench (3, 4, 5mm) ......................1 Ea.
B. Drift Key ...................................................... 1
C. Bottle for Oil ............................................... 1
D. Open-End Wrench 22–24mm..................... 1
E. Open-End Wrench 17–19mm ..................... 1
F. Drill Chuck Key ........................................... 1
G. Drill Chuck B16, 1–13mm ........................... 1
H. Drill Chuck Arbor R-8–MT#3 ...................... 1
I. Spindle Sleeve R-8–MT#3 ......................... 1
J. Spindle Sleeve MT#3–MT#2 ...................... 1
K. Hardware Bag (Not Shown) ........................ 1
— Hex Nuts M12-1.75 .................................. 2
— T-Bolts M12-1.75 x 55.............................. 2
—Flat Washers 12mm ................................ 2
L. Toolbox (Not Shown) .................................. 1
Figure 5. Model G0779 toolbox contents.
B
A
C
D
E
F
G
I
J
H