Filter
Top Products
-20-
Model G0779 (Mfd. Since 09/14)
Positioning Table
The table moves vertically, rotates 360°, pivots
around the column, and tilts 60° left or right.
1. Remove any loose objects from table surface.
2. Loosen lock handle shown in Figure 12.
Figure 12. Lock handle for controlling table
rotation.
1. Remove any loose objects from table surface.
2. Loosen table lock handles (see Figure 11).
3. Pivot table to desired location.
Note: Ensure rack (see Figure 11) moves
smoothly around column without binding in
upper/lower guide rings.
4. Retighten lock handles.
1. Remove any loose objects from table surface.
2. Loosen table lock handles shown in Figure 11.
3. Adjust table height by rotating table elevation
crank (see Figure 11), then retighten table
lock handles.
Figure 11. Table elevation and rotation controls.
Table
Lock
Handles
Table
Elevation
Crank
Tool Needed Qty
Open-End Wrench 19mm .................................. 1
Raising/Lowering Table
Pivoting Table Around Column
Rotating Table
1. Remove all objects from table surface.
2. Loosen three hex nuts shown in Figure 13.
3. Tilt table until pointer aligns with desired
angle on scale (see Figure 13).
3. Rotate table to desired position, then retighten
lock handle.
Tilt Angle
Pointer & Scale
Hex Nuts
(2 of 3)
Tilting Table
4. Retighten hex nuts.
Figure 13. Table tilt controls.
Rack
Lock
Handle