Filter
Top Products
Model G0779 (Mfd. Since 09/14)
-19-
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not
intended to be an instructional guide. To learn
more about specific operations,
read this entire
manual and
seek additional training from expe-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1. Examines workpiece to make sure it is suit-
able for drilling.
2. Installs correct tooling for the operation.
3. Firmly secures workpiece to table using a
vise or T-slot clamps.
4. Adjusts table to correct height, then locks it in
place.
5. Adjusts headstock elevation to correct height,
then locks it in place.
6. Puts on required safety glasses and face
shield.
7. Connects machine to power.
8. Selects spindle RPM with speed control
levers and rotates spindle direction switch to
turn machine ON.
9. Begins drilling.
10. When finished, rotates spindle direction
switch to STOP and disconnects machine
from power.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.