Filter
Top Products
Model G0779 (Mfd. Since 09/14)
-21-
Positioning
Headstock
4. Retighten hex nuts before connecting to
power.
The Model G0779 headstock moves vertically,
pivots 360° around the column, and tilts 90° left
or right.
Tools Needed Qty
Wrench 24mm ................................................... 1
Wrench 22mm ................................................... 1
1. DISCONNECT MACHINE FROM POWER!
2. Loosen two hex nuts shown in Figure 14.
Figure 15. Location of head elevation crank.
Head
Elevation
Crank
1. DISCONNECT MACHINE FROM POWER!
2. Loosen hex nuts shown in Figure 14.
3. Make sure headstock and cords can move
unobstructed, then manually rotate head-
stock around column Figure 15.
4. Retighten hex nuts before connecting to
power.
3. Use head elevation crank shown in Figure 15
to adjust headstock height.
Raising/Lowering Headstock
Pivoting Headstock Around Column
Figure 14. Location of hex nuts that lock
headstock to column.
Hex
Nuts