Filter
Top Products
Model G7943/G7944 (Mfg. 10/02+)
-21-
Figure 17. Downfeed handles and belt cover
knob installed.
Components and Hardware Needed: Qty
Downfeed Handles .............................................3
The downfeed handles must be installed to prop-
erly operate the drill press.
To install the downfeed handles:
1. Thread the handles into the spindle hub, as
shown in Figure 17, and tighten.
2. Install the belt cover knob in its place (see
Figure 17 for location).
Downfeed Handles &
Belt Cover Knob
Belt Cover
Knob
Spindle
Hub
Components and Hardware Needed: Qty
Table ...................................................................1
The table must be installed to properly support
the workpiece during operation.
To install the table:
1. Insert the table shaft into the table support
assembly.
2. Tighten the small locking lever (Figure 18) to
secure the table in the table support assem-
bly.
Ta b l e
Figure 18. Table installed.
Small Lock
Lever