Filter
Top Products
-4-
Model G0794 (Mfd. Since 09/14)
The laser should be checked and adjusted before
starting a new project, and any time you raise or
lower the table, or change workpiece thickness.
Laser Guide
7. Adjust laser (Figure 2), positioning it by hand
so crosshairs align with indentation you made
earlier in surface of workpiece, as shown in
Figure 3.
DO NOT look directly into laser. Severe eye
injury will result.
To adjust laser:
1. DISCONNECT DRILL PRESS FROM
POWER!
2. Install drill bit in chuck (see Installing/
Removing Drill Bits on Page 25 of Model
G7944 manual).
3. Clamp workpiece securely to table.
4. Adjust table so workpiece is within range of
drill bit, then lock table in horizontal position.
5. Lower drill bit so it touches workpiece, mak-
ing a slight indentation in the surface, then
raise bit.
6. Connect drill press to power. Turn laser
ON using switch on front of drill press (see
Figure 1).
Figure 1. Location of laser ON/OFF switch.
Laser ON/
OFF Switch
Figure 2. Location of laser.
Figure 3. Crosshairs aligned with indentation on
workpiece.
Indentation