Filter
Top Products
Model G0794 (Mfd. Since 09/14)
-5-
Digital Readout
3. Remove (4) M4 x 12 tap screws shown in
Figure 5, and remove DRO unit from hous-
ing.
Figure 5. DRO housing removed from drill press
head.
x 4
4. Lay DRO unit on a flat surface and remove
battery cover, as shown in Figure 6.
Figure 6. DRO battery cover removed.
DRO Unit
Battery Cover
5. Replace battery with new SR44 button cell
battery and re-install battery cover.
6. Re-install DRO unit and DRO housing, mak-
ing sure to re-install shoulder screw from
Step 2.
The model G0794 is equipped with a digital read-
out (DRO) for precision spindle adjustment. The
DRO is independently powered by a SR44 but-
ton cell battery, which may need to be changed
from time to time. Follow the instructions below to
change the battery.
Tools Needed: Qty
Phillips Head Screwdriver #2 ............................ 1
To change DRO battery:
1. DISCONNECT DRILL PRESS FROM
POWER!
2. Remove (1) shoulder screw, then remove (4)
M5-.8 x 14 Phillips head screws shown in
Figure 4 and remove DRO housing.
Figure 4. Location of DRO mounting screws.
x 4
x 1
Battery