Filter
Top Products
G1006/7 Heavy Duty Mill/Drill
-15-
The unpainted surfaces are coated with a waxy
oil to prevent corrosion during shipment. Remove
this protective coating with a solvent cleaner
or degreaser shown in Figure 5. For thorough
cleaning, some parts must be removed. For opti-
mum performance from your machine, clean
all moving parts or sliding contact surfaces.
Avoid chlorine-based solvents, such as acetone
or brake parts cleaner that may damage painted
surfaces. Always follow the manufacturer’s instruc-
tions when using any type of cleaning product.
Clean Up
Gasoline and petroleum
products have low flash
points and can explode
or cause fire if used to
clean machinery. DO
NOT use these products
to clean the machinery.
Many cleaning solvents
are toxic if inhaled.
Minimize your risk by only
using these products in a
well ventilated area.
G2544—Solvent Cleaner & Degreaser
A great product for removing the waxy shipping
grease from your machine during clean up.
Figure 5. Cleaner/degreaser available from
Grizzly.
In addition to the parts shown in Figure 3, the
Model G1007 comes with the power feed and its
attachment accessories.
Power Feed (G1007 Only) (Figure 4) Qty
K. Cap Screws ¼-20 x 1-½ (End Stops) ......... 2
L. Flat Washers ¼" (End Stops) ..................... 2
M. End Stops ................................................... 2
N. End Stop Clamp Plates .............................. 2
O. Hex Bolts M8-1.25 x 25 (Power Feed) ....... 2
P. Lock Washers 8mm (Power Feed) ............. 2
Q. Flange Bushings 8mm (Power Feed) ......... 2
R. Powerfeed Mounting Bracket ..................... 1
S. Hex Bolts w/Tapered Tip M8-1.25 x 25
(Power Feed) .............................................. 2
T. Gear Cover ................................................. 1
U. Limit Switch Plate ....................................... 1
V. Cap Screws M8-1.25 x 12 (Stop Bracket) .. 4
W. Flat Washers 8mm (Stop Bracket) ............. 2
X. Powerfeed Unit (Not Shown) ...................... 1
Note: If you can't find an item on these lists, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 4. G1007 Power feed Inventory.
M
N
T
U
K
L
O
P Q
R
S
V
W