Filter
Top Products
G1006/7 Heavy Duty Mill/Drill
-13-
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
110/220V Operation
SECTION 2: CIRCUIT REQUIREMENTS
Full Load Amperage Draw
Amp Draw at 110V (prewired) ................18 Amps
Amp Draw at 220V ..................................9 Amps
Power Supply Circuit Requirements
You MUST connect your machine to a grounded
circuit that is rated for the amperage given below.
Never replace a circuit breaker on an existing cir-
cuit with one of higher amperage without consult-
ing a qualied electrician to ensure compliance
with wiring codes. If you are unsure about the
wiring codes in your area or you plan to con-
nect your machine to a shared circuit, consult
a qualified electrician.
Minimum Circuit Size (110V) ................. 20 Amps
Minimum Circuit Size (220V) ................. 15 Amps
Power Connection Device
The Model G1006/7 comes prewired for 110V
and includes a NEMA 5-15 plug. If you rewire the
motor to 220V, we recommend using the plug and
receptacle shown in Figure 2 for 220V.
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. Compliance MUST
be verified by a qualified
electrician!
Extension Cords
Using extension cords may reduce the life of the
motor. Instead, place the machine near a power
source. If you must use an extension cord:
• For 110V, use at least a 10 gauge cord that
does not exceed 50 feet in length.
• For 220V, use at least a 14 gauge cord that
does not exceed 50 feet in length.
• The extension cord must have a ground wire
and plug pin.
<gdjcY^c\Egdc\^h
Adc\Zhid[i]ZI]gZZ
Egdc\h
8jggZci
8Vggn^c\Egdc\h
<gdjcYZY
DjiaZi
Figure 2. Recommended plug types.
5-15 Plug
for 110V
6-15 Plug & Outlet
for 220V
NOTICE
The Model G1006/7 is prewired for 110V
operation. If you plan to operate your
machine at 220V, the motor must be rewired
(see Page 37).