Filter
Top Products
G1006/7 Heavy Duty Mill/Drill
-19-
4. Plug the rapid switch cord into the receptacle
provided on the bottom of the power feed
body.
5. Screw the knob onto the direction handle.
6. Place the plastic gear cover to the bottom of
the power feed to protect the gears.
7. Insert the end stops into the slot on the front
edge of the table, then tighten them (Figure
13).
8. Remove the center travel stop at the front of
the table. Save the mounting bolts.
9. Secure the switch bracket to the front of the
Mill/Drill. Use the mounting bolts saved in
Step 8 (Figure 14).
Figure 14. Limit switch bracket.
10. Mount the switch to the switch bracket with
the cap screws provided. When the switch
is depressed, the power feed automatically
turns Off and table movement stops (Figure
15).
Figure 15. Limit switch.
Switch Bracket
Limit Switch
NOTICE
Before using the G1007, place the power
feeder cord and the control cord for the
microswitch clear of any movements which
could pinch or crush them. Before using
the power feed, mark the maximum dis-
tance the table can move before the power
feed comes in contact with the machine’s
base. Use that mark as a reference each
time you re-adjust your table stops. This is
the best way to avoid damaging the power
feed and/or causing an unsafe condition.
Figure 13. End stop.
End Stop