Grizzly G1010 Saw User Manual


 
-18-
G1010 4" x 6" Metal-Cutting Bandsaw
Figure 13. Installing pulley cover.
Pulley Cover
Components and Hardware Needed: Qty
Pulley Cover ......................................................
1
Pan Head Screw
1
4"-20 x
5
8" ..............................2
To install the pulley cover:
1. Slide the pulley cover over the drive-shaft.
2. Align the holes and secure with the two
1
4"-
20 x
5
8" screws (see Figure 13).
3. Attach the bandsaw to the stand with 8 hex
bolts, 16 flat washers and 8 hex nuts and
tighten with a 12mm wrench (see
Figure
12).
Figure 12. Front view of bolt locations.