Grizzly G1010 Saw User Manual


 
G1010 4" x 6" Metal-Cutting Bandsaw
-23-
Starting the machine:
1. Read the entire instruction manual.
2. Make sure all tools and foreign objects have
been removed from the m
achine.
3. Put on safety glasses and secure loose
clothing o
r long hair.
4. Raise the bandsaw by the handle.
5. Start the bandsaw while keeping your finger
near the
ON/OFF switch at all times dur-
ing the test run (
Figure 26). The bandsaw
should run smoothly with little or no vibra-
tion.
If you suspect any problems, immediately
stop the bandsaw and correct before con
-
tinuing.
—If you need any help with your bandsaw
call our Tech Support at (570) 546-9663.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
The adjustments listed below have been per-
formed at the factory. However, because of
the many variables involved with shipping, we
recommend that you at least verify the following
adjustments to ensure the adjustments remain
unchanged.
Step-by-step instructions on verifying these adjust
-
ments can be found in SECTION 7: SERVICE
ADJUSTMENTS.
Factory adjustments that should be verified:
1. Blade Tracking (Page 32).
2. Squaring the Blade (Page 33).
3. Blade Guide Bearings (Page 34).
Recommended
Adjustments
Figure 26. ON/OFF switch.
Test Run