Grizzly G1010 Saw User Manual


 
-20-
G1010 4" x 6" Metal-Cutting Bandsaw
Work Stop
Components and Hardware Needed: Qty
Work Stop ...........................................................
1
Work Stop Shaft .................................................
1
To install the work stop:
1. Slide the work stop shaft into the casting
until it reaches the stop.
2. Tighten the set screw with the 4mm hex
wrench as shown in
Figure 18.
Figure 19. Installing work stop.
Figure 18. Installing work stop shaft.
Vise Handwheel
Components and Hardware Needed: Qty
Handwheel ..........................................................1
Handwheel Handle .............................................
1
To install the handwheel:
1. Attach the handwheel handle to the
handwheel.
2. Slide the handwheel onto the shaft and
tighten the set screw with a 4mm hex wrench
(see Figure 17).
Figure 17. Installing handwheel.
3. Slide the work stop onto the work stop shaft
and tighten the setscrew.
4. Position it down and out of the way for longer
stock, as shown in
Figure 19, or set the work
stop to a measured distance from the blade
for consistent, repeatable cut lengths.