Filter
Top Products
-30-
G1010 4" x 6" Metal-Cutting Bandsaw
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person
-
al injury.
Lubrication
Cleaning the Model G1010 is relatively easy. After
using your bandsaw, remove excess chips by
sweeping.
Cleaning
SECTION 6: MAINTENANCE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
:
• Loose mounting bolts.
• Damaged saw blade.
• Worn or damaged wires.
• Any other unsafe condition.
• Clean after each use.
Monthly Check:
• V-belt tension, damage, or wear.
• Lubricate vise screw.
Annual Check:
• Lubricate gear box.
Schedule
Before applying lubricant to any area, wipe the
area clean to avoid contamination.
Lubricate the
vice screw shown in Figure 44 with general pur
-
pose grease.
Figure 44. Vise screw lubrication.
Figure 45. Gear box lubrication.
Gear Box
Remove the cover on the gear box in Figure 45
and coat the gears with general purpose grease.