Grizzly G1010 Saw User Manual


 
G1010 4" x 6" Metal-Cutting Bandsaw
-21-
Vertical Assembly
Components and Hardware Needed: Qty
Table ...................................................................1
Bracket ...............................................................1
Flat Head Screw
1
4"-20 x
1
2" ..............................1
Former Switch Safety Bracket ............................
1
Hex Nut
1
4"-20 ....................................................1
To assemble the bandsaw for vertical cutting:
1. Remove the blade guide cover as shown in
Figure 20.
Figure 20. Removing blade guide cover.
Figure 21. Table and bracket installed.
Figure 22. Squaring table to blade.
2. Install the table and replace the two screws
removed in Step 1.
3. Install the bracket shown in Figure 21 with
the bolt already in the casting and the flat
head screw, and the hex nut.
4. Set a square to the side of the blade, as
shown in Figure
22, and adjust the bracket
to square the table to the blade.
The Model G1010 can easily be set up for vertical
cutting operations.
Bolt Already
in Casting