Grizzly G1010 Saw User Manual


 
G1010 4" x 6" Metal-Cutting Bandsaw
-19-
Components and Hardware Needed: Qty
V-Belt ..................................................................1
To install the V-belt:
1. UNPLUG THE BANDSAW!
2. Lift the motor and slip the V-belt over both
pulleys as shown in
Figure 14. Make sure
the belt is on parallel sheaves.
V-Belt
Figure 16. V-belt in place and tensioned.
3. Lower the motor, apply downward pres-
sure on the motor base and adjust the V-
belt tension knob to tension the belt (see
Figure 15). Apply enough tension so the belt
deflects about
1
2" with moderate pressure
when pinched together at the points shown
in Figure 16.
4. Close the pulley cover.
Figure 15. V-belt tension knob.
V-Belt Tension Knob
Figure 14. Installing V-belt.