Filter
Top Products
-12-
G1021X 15" Extreme Series Planer
Inventory
After all the parts have been removed from the
two boxes, you should have the following items:
Box 1: (Figure
3) Qty
A. Planer Unit (not shown) ..............................
1
B. Extension Tables ........................................ 2
C. Dust Port .................................................... 1
D. Handwheel ................................................. 1
Tools and Hardware:
Cap Screws M6-1 x 12 (Dust Port) ...................
3
Hex Bolts M6-1 x 12 (Dust Port) .......................
3
Hex Nuts M6-1 (Dust Port) ................................
3
Lock Washers 6mm (Dust Port) ........................
3
Flat Washers 6mm (Dust Port) ..........................
3
Hex Bolts M8-1.25 x 25 (Ext. Tables) ...............
6
Set Screws M8-1.25 x 20 (Ext. Tables) ............
6
Hex Nut M10-1.25 (Handwheel) ........................
1
Flat Washer 10mm (Handwheel) ......................
1
Scale (Hi-Lo) (Handwheel) ................................
1
Key 4 x 4 x 10 (Handwheel) ..............................
1
Handwheel Handle (Handwheel) .......................
1
Torx T-Handle Wrench
1
⁄2" ................................. 1
Flat Head Torx Screws M6-1 x 15 ..................
10
Torx Bits T-20 ....................................................
5
Indexable Carbide Inserts .................................
5
Hex Wrenches 3, 4, 5, 6mm ....................... 1 ea.
Wrenches 8/10, 12/14mm ........................... 1 ea.
In the event that any nonproprietary parts are
missing, we would be glad to replace them, or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 3. G1021X Component Inventory.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
Clean Up
The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship
-
ment. Remove this protective coating with a sol
-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed. For opti
-
mum performance from your machine, make
sure you clean all moving parts or sliding
contact surfaces that are coated. Avoid chlo
-
rine-based solvents, such as acetone or brake
parts cleaner, as they may damage painted sur
-
faces should they come in contact. Always follow
the manufacturer’s instructions when using any
type of cleaning product.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest
-
ed. Lack of ventilation
while using these sol
-
vents could cause seri
-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area.
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
B
C
D