Filter
Top Products
-2- G1037 Planer / Moulder
WARNING: For Your Own Safety Read Instruction
Manual Before Operating Planer-Moulder
Safety Instructions For Power Tools
These safety rules cannot cover every situation in a workshop. Consider your conditions when setting up
or operating your planer-moulder.
SECTION 1: SAFETY
a) Always wear eye protection.
b) Be sure all guards are in place before oper-
ating equipment.
c) Read the operators manual thoroughly and
familiarize yourself with the machine before
attempting to operate.
d) Support the workpiece adequately at all
times during operation; maintain control of
the work at all times.
e) Do not attempt to perform an abnormal or
little-used operation without study and the
use of adequate hold-downs, jigs, fixtures,
stops, and the like.
9. USE PROPER EXTENSION CORD. Make
sure your extension cord is in good condition.
When using an extension cord, be sure it is
rated Hard Service (grade S) or better.
Conductor size must be 14 A.W.G. for cords
up to 50 feet in length. An undersized cord
will cause a drop in line voltage resulting in
loss of power and overheating. Your exten-
sion cord must also contain a ground wire
and plug pin. Always repair or replace exten-
sion cords if they become damaged.
10. WEAR PROPER APPAREL Do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Nonslip footwear is
recommended. Wear protective hair covering
to contain long hair.
11. ALWAYS USE SAFETY GLASSES. Also
use face or dust mask if cutting operation is
dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT safety
glasses.
12. SECURE WORK. Use clamps or a vise to
hold work when practical. It’s safer than
using your hand and frees both hands to
operate tool.
1. KEEP GUARDS IN PLACE and in working
order.
2. REMOVE ADJUSTING KEYS AND
WRENCHES. Form habit of checking to see
that keys and adjusting wrenches are
removed from tool before turning on.
3. KEEP WORK AREA CLEAN. Cluttered
areas and benches invite accidents.
4. DON’T USE IN DANGEROUS ENVIRON-
MENT. Don’t use power tools in damp or
wet locations, or expose them to rain. Keep
work area well lighted.
5. KEEP CHILDREN AWAY. All visitors
should be kept a safe distance from work
area.
6. MAKE WORK SHOP KID PROOF with
padlocks, master switches, or by removing
starter keys.
7. DON’T FORCE TOOL. It will do the job bet-
ter and safer at the rate for which it was
designed.
8. USE RIGHT TOOL. Don’t force tool or
attachment to do a job for which it was not
designed.