Filter
Top Products
G1847 / G1852 / G 1861 / G3811 Air Nailers/Staplers -3-
Safety Instructions for Nail Guns
17. CHECK DAMAGED PARTS. Before further
use of the tool, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function-check for
alignment of moving parts, binding of mov-
ing parts, breakage of parts, mounting, and
any other conditions that may affect its
operation. Damaged parts should be prop-
erly repaired or replaced immediately.
18. DIRECTION OF FEED. Feed work into a
blade or cutter against the direction of rota-
tion of the blade or cutter only.
19. NEVER LEAVE TOOL RUNNING UNAT-
TENDED. TURN POWER OFF. Don’t leave
tool until it comes to a complete stop.
7. Use only clean, dry, regulated, compressed
air. DO NOT connect this air tool to any pres-
surized gas other than compressed air.
8. Air compressors must comply with ANSI B
19.3 - 1981 (U.S.), “Safety Standard for
Compressors for Process Industries.”
9. DO NOT operate at a pressure higher than
90 PSI.
10. NEVER use this nailer for fastening alu-
minum, brass, metal, plastics, or any other
like material.
11. Air hose must be rated as having a minimum
working pressure of 150 p.s.i. or 150% of the
maximum pressure produced in the line,
whichever is greater. Inspect air hoses fre-
quently.
12. All air tools exhaust compressed air. If work-
ing in an area where dust will become air-
borne due to exhausted air, WEAR RESPI-
RATORY PROTECTION.
1. Make sure the safety nose is functioning
properly before loading fasteners.
2. Make sure the magazine spring is set
before operating.
3. ALWAYS point nailer away from yourself
and others when loading or operating.
4. DO NOT carry nailer with your finger on
the trigger. Nailer will fire if safety nose is
accidentally depressed.
5. DO NOT place your free hand or feet near
the nailer tip to support the work. If you
cannot safely support the work without
placing body parts near the nailer tip, do
not use this nailer.
6. DO NOT operate the nailer if workpiece is
between you or someone else and the
nailer. Reposition yourself so you and oth-
ers are behind the nailer.
13. MAINTAIN TOOLS WITH CARE. Keep
tools sharp and clean for best and safest
performance. Follow instructions for lubri-
cating and changing accessories.
14. DISCONNECT TOOLS before servicing
and changing accessories, such as blades,
bits, cutters, and the like.
15. REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure switch is in off posi-
tion before plugging in.
16. USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recom-
mended accessories. The use of improper
accessories may cause risk of injury.
Safety Instructions For Power Tools