Filter
Top Products
Figure 4. Staple placement.
Figure 3. Releasing the magazine.
G1847 / G1852 / G 1861 / G3811 Air Nailers/Staplers -7-
To load the stapler:
1. Disconnect the air hose if connected.
2. Press down on the magazine latch that holds
the magazine in place. Figure 3.
3. Slide the magazine out and place the staples
into the nailer. The staples will seat over the
guide in the magazine. Figure 4.
4. Close the magazine. The magazine latch will
click into place if the staples are loaded cor-
rectly.
Loading Staples
Staples
Magazine Latch
DO NOT load or service any pneumatic nail-
er or stapler without first disconnecting it
from its air source. Failure to do so could
result in a misfire and possible serious
injury to the operator or others in the work
area.
DO NOT operate these pneumatic guns
without wearing ANSI-approved goggles or
safety glasses. Be sure that you are not
wearing loose-fitting clothing or jewelry that
could become entangled with the trigger
and cause misfires. Serious personal injury
could result. Never attempt to disconnect
the safety mechanisms on any of these
guns. In addition to voiding their warranties,
doing so could result in serious injury to the
operator or others in the work area.
NOTE
Be sure that staples are in good condition
before attempting to load them into the gun.
Rusty, corroded, damaged, or incorrectly-
sized staples should not be used. Loading
small, partial bands of staples can also jam
the gun.