Filter
Top Products
-12- G4227 Sliding Table
Figure 12.
Figure 13. Roller adjustment.
15. Raise the pinch rollers back up and tighten
the nuts. Roll back the eccentric slightly if the
table travel is stiff.
16. Mount the fence by sliding the plastic T-nuts
into the bottom of the fence. Insert the short
stud into the hole closest to the machine
table, the longer stud with spacer goes
through the sliding mount. Figure 14. Install
the lock handles from below.
14. Now loosen the eccentric roller shaft nuts
slightly and rotate the eccentric shafts until
the sliding table is about
1
⁄16
'' above the
machine table. Tighten the nuts down and
recheck the sliding table height. Fine tune
the table height by turning the upper grooved
roller eccentric shafts without loosening the
nut. Figure 13.
Figure 14. Mounting the fence.
Figure 15. Adjusting the lower guide.
17. Set the sliding table fence so it extends to
the saw blade or shaper fence. Figure 15.
Loosen the lower bearing guide shaft nut
and rotate the eccentric shaft from below the
bearing until the end of the fence almost
touches the machine table. Retighten the
nut. NOTE: If the eccentric does not provide
sufficient travel, the threaded mounting studs
on the lower guide rail assembly can be
adjusted by turning the nuts on either side of
the bracket.