Filter
Top Products
-11-
G8030 3 H.P. Overarm Router
Air Tubes/Foot
Switch Connection
The foot switch controls the direction of vertical
spindle travel. Step on the switch and the spindle
comes down. Step off the switch and the spindle
rises from the work area.
1. Turn the yellow switch housing upside down.
2. Insert the three hoses—blue, yellow and
orange—through the grommet in the back of
the housing.
3. Make sure each hose is aligned with the cor-
rect fitting before inserting, as removal is diffi-
cult as shown in Figure 4.
Figure 4. Installing air hoses.
Spindle Rotation
Check
The Model G8030 spindle must rotate in the direc-
tion of the arrow on the face of the machine.
To check rotation:
1. Disconnect the machine from the power
source.
2. Turn the spindle by hand as shown in Figure
3.
3. Make sure the nut is secure.
4. Start the machine and observe the direction of
the spindle travel.
5. If the spindle rotates in the opposite direction,
call our customer service department for help.
Figure 3. Spindle and nut. Note arrow direction.
Make certain the spindle nut is secure and
your hand is well away before starting the
motor. If either condition is not met, it is
highly possible there will be an injury to the
operator.
Orange
Yellow
Blue
The foot switch is never used when the
spindle is not running. Make sure the spin-
dle is turning before stepping on the foot
switch.
!
Make sure that your
hands and fingers are
not in the path of the
router bit before acti-
vating the foot pedal.
Failure to do so could
result in serious per-
sonal injury.
NOTICE