Filter
Top Products
Model T10010 Wet Grinder-14-
To fill and position the reservoir:
1. Make sure the grinder is disconnected
from power and that the grinding wheel
is not rotating.
2. Remove reservoir and fill with water to
just below the V-shaped notch.
3. Attach the reservoir to the grinder.
— If the grinder is going to be used
immediately, position the reservoir
in the grinding position by attaching
it in the upper slot (Figure 9).
— If the grinder is not going to be used
immediately, position the reservoir
in the storage position by attaching
it in the lower slot (Figure 10).
Note: Placing the reservoir in the stor-
age position prevents damage to the
wheel and potential hazards from being
stored in water.
Figure 9. Grinding position.
Figure 10. Storage position.
Water Reservoir
The Model T10010 Wet Grinder is designed
for wet grinding and should never be used
without water.
Before filling the water reservoir, identify
the high and low reservoir mounting slots.
These slots allow the reservoir to be raised
during grinding and lowered when not in
use.
The mounting tabs on the reservoir serve
as hooks to attach to the reservoir mount-
ing slots (Figure 8).
Figure 8. Reservoir mounting positions.
Lower Slot
(Storage)
Mounting
Tab
Upper Slot
(Grinding)
DO NOT attempt to use the grinding
wheel without filling the reservoir
with water. Overheating caused by
lack of lubrication could damage the
grinding wheel, as well as the tool
or blade you are grinding. Ensure
that the reservoir is filled with clean
water. Sediment-filled water can clog
the wheel and lessen the effective-
ness of the grinder.
NOTICE