Filter
Top Products
Model T10010 Wet Grinder-8-
CIRCUIT REQUIREMENTS
Figure 1. Plug & receptacle type.
Amperage Draw
The Model T10010 motor draws the follow-
ing amps under maximum load:
Motor Draw.......................................3 Amps
Minimum Circuit Requirement
We recommend connecting your machine
to a dedicated and grounded circuit that
is rated for the amperage given below.
Never replace a circuit breaker on an exist-
ing circuit with one of higher amperage
without consulting a qualified electrician
to ensure compliance with wiring codes. If
you are unsure about the wiring codes
in your area or you plan to connect your
machine to a shared circuit, consult a
qualified electrician.
110V Circuit...................................15 Amps
Plug/Receptacle Type
Included Plug Type...................NEMA 5-15
110V Operation
This machine must have a ground
prong in the plug to help ensure that it
is grounded. DO NOT remove ground
prong from plug to fit into a two-
pronged outlet! If the plug will not
fit the outlet, have the proper outlet
installed by a qualified electrician.
Electrocution or fire
could result if this
machine is not ground-
ed correctly or if your
electrical configuration
does not comply with
local and state codes.
Ensure compliance by
checking with a quali-
fied electrician!
Extension Cords
We do not recommend the use of exten-
sion cords, but if you find it absolutely
necessary:
• Use at least a 14 gauge cord that does
not exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• A qualified electrician MUST size cords
over 50 feet long to prevent motor dam-
age.