Filter
Top Products
Model T10010 Wet Grinder -15-
Here are some tips for using your wet
grinder water reservoir:
• Check the water level before every use
and be sure the wheel is wet before
you begin grinding. DO NOT use the
grinder without water.
• Leaving the grinding wheel stored in
water will cause damage to the wheel
and create potential hazards because
the wheel will become unbalanced.
Once any grinding process is complete,
return the reservoir to the storage posi-
tion to prevent prolonged water expo-
sure to the wheel.
• Empty, rinse, and refill the reservoir
regularly. This prevents metal and
stone from accumulating in the reser-
voir.
• Place a magnet in the reservoir to
catch and collect metal filings. This will
help prevent excessive metal accumu-
lation on the grinding wheel.
Angle Guide
The Model T10010 Wet Grinder comes
with an angle guide to help identify and
maintain the cutting angle on a variety of
tools.
2. Find the angle notch that best fits the
tool you wish to grind by placing the
sharpened edge of the workpiece into
each notch.
3. Place the angle guide on the wheel
with the desired angle notch (found in
Step 2) against the wheel and adjacent
to the universal support (Figure 12).
Figure 11. Measuring notches.
Figure 12. Angle guide usage.
Desired
Angle Notch
Angle Edge
Correct
Grinding Angle
DO NOT allow the grinding wheel
to stay immersed in water for long
periods of time without running. The
water can cause the wheel to become
waterlogged and unbalanced and
may cause sections of the wheel to
break off when the grinder is started.
Always empty or lower the reservoir
to the storage position when the
grinder will not be used.
To use the angle guide:
1. Locate the eight measuring notches on
the angle finder (Figure 11).
4. Adjust the positioning of the tool and
the universal support height as neces-
sary so that the sharpened edge of
the tool is flat against both the grind-
ing wheel and the angle edge on the
angle guide as shown in Figure 12. For
precision grinding attachments, see
Accessories on Page 17.
Desired
Angle Notch
Measuring
Notches
Workpiece
Angle Edge
Workpiece