Filter
Top Products
Model T10010 Wet Grinder-20-
SECTION 7: SERVICE
Symptom Possible Cause Solution
Motor will not start;
fuses or circuit
breakers blow
1. Disabling key is at fault.
2. Open circuit in motor or loose
connections.
3. Start capacitor is at fault.
4. Short circuit in motor or loose
connections.
5. Incorrect fuses or circuit
breakers in power supply.
1. Install/replace disabling
key; replace switch.
2. Inspect/repair all lead con-
nections on motor for loose
or open connections.
3. Replace start capacitor.
4. Inspect all connections on
motor for loose or shorted
terminals or worn insula-
tion.
5. Install correct fuses or cir-
cuit breakers.
Motor slows, stops,
or will not start;
fuses or circuit
breakers blow.
1. Motor overloaded.
2. Short circuit in motor or loose
connections.
1. Reduce load on motor.
2. Inspect connections on
motor for loose or shorted
terminals or worn insula-
tion.
Troubleshooting
Motor and Electrical