Filter
Top Products
-12-
Model T25688 (Mfg. Since 09/13)
The main rollers of this
machine present a pinch-
ing hazard. Make sure no
body part or clothing is
near the area between the
rollers. Failure to follow this
warning may result in fin-
gers, hair, or clothing being
pulled into the machine,
causing personal injury.
Flat RollingPreparation
Before every use, follow these procedures to set
up the slip roll for safe, accurate, and efficient use.
To prepare the slip roll for use:
1. Turn the thickness adjustment knob to lower
the bottom roller to approximately
1
/4" below
the top roller. Use calipers or a spacer to set
the distance between the rollers evenly at
each end (see Figure 10).
2. Lower the rear roller until it is approximately
even with the bottom roller (see Figure 10).
Use calipers or a spacer to set the rear roller
even with the bottom roller at each end.
Figure 10. Slip roll preparation.
CCW
CCW
Rear Roller
This slip roll can be used to flat roll sheet metal up
to 22 gauge. This can be done to straighten and
slightly flatten workpieces.
CW
Figure 11. Raising bottom roller for flat rolling.
To flat roll a workpiece:
1. Place the workpiece between the top and
bottom rollers, as shown in Figure 11. Turn
the thickness adjustment knobs to lift the
bottom roller until the workpiece is held snug
between the top and bottom rollers. Be sure
to turn the thickness adjustment knobs equal
amounts.