Filter
Top Products
Model T25688 (Mfg. Since 09/13)
-21-
Review the troubleshooting and procedures in this section if a problem develops with your machine. If you
need replacement parts or additional help with a procedure, call our Technical Support at (570) 546-9663.
Note: Please gather the serial number and manufacture date of your machine before calling.
SECTION 6: SERVICE
Troubleshooting
Symptom Possible Cause Possible Solution
Slip roll creates
cones when trying
to create cylinders.
1. Rollers are not parallel. 1. Adjust rear roller adjustment knobs as necessary to
be sure the rear roller and top roller are parallel.
A noticeable crease
is formed in the
workpiece.
1. Excessive pressure applied in one spot. 1. Reduce the radius and perform the bend in several
passes.
Crank does not
turn top and bottom
rollers.
1. Bottom roller adjustment screws not
engaged.
2. Gears are damaged.
1. Engage bottom roller adjustment screws.
2. Check/replace gears.
Slip roll does not
bend material.
1. Machine capacities exceeded.
2. Rear roller not engaged.
1. Use materials within the capacity of the slip roll.
2. Check/adjust rear roller.