Filter
Top Products
-14-
Model T25688 (Mfg. Since 09/13)
3. Turn the radius adjustment knobs to lift the
rear roller until the desired radius bend is
reached (see Figure 16). Make sure to turn
the knobs equal amounts so the rear roller is
always parallel with the other rollers. Failure
to do so will create a larger radius on one end
than the other, resulting in a cone or spiral
shape.
CW
Figure 16. Setting the radius.
2. Turn the crank clockwise to feed the workpiece
until its edge is directly above the rear roller,
as shown in Figure 15.
Figure 15. Feeding the workpiece.
4. Turn the crank to process the material
through the slip roll. Continue turning until
the workpiece is completely through the top
and bottom rollers (see Figure 17).
Figure 17. Processing the workpiece.
This machine poses a cut-
ting hazard if workpieces
are not properly handled
when exiting the rollers. If
necessary, get assistance
to support the workpiece.
Make sure all helpers are
wearing safety glasses
and leather gloves when
assisting in the use of this
machine.
Eye injury hazard! Always
wear safety glasses when
using this machine.
Depending on the size and shape of the
workpiece, you may need assistance to sup-
port the workpiece as it exits the machine.
Failure to adequately support the workpiece
may result in the workpiece falling, causing
injuries.