Filter
Top Products
-16-
Model T25688 (Mfg. Since 09/13)
3. Turn the radius adjustment knobs to lift the
rear roller until the desired radius bend is
reached (see Figure 20). Make sure to turn
the knobs equal amounts so the rear roller is
always parallel with the other rollers. Failure
to do so will create a larger radius on one end
than the other, resulting in a cone shape.
Note: Always err on the side of making the
radius too large rather than too small. It is
easy to decrease the radius but very difficult
to increase the radius later.
CW
Figure 20. Setting the radius.
2. Turn the crank clockwise to feed the workpiece
until it is approximately half way through the
rollers.
4. Turn the crank to process the material
through the slip roll. Continue turning until
the workpiece is completely through the top
and bottom rollers (see Figure 21).
Figure 21. Processing the workpiece.
Figure 22. Re-inserting the workpiece.
Figure 23. Creating the cylinder.
5. Rotate the workpiece 180˚, insert the curved
end into the slip roll, then process the
workpiece through the machine, as shown in
Figures 22–23.