Filter
Top Products
ADJUSTMENTS
-16-
NOTICE
You can adjust the relative position of the
fence mount lock handle head by pulling
and rotating the head either clockwise or
counter-clockwise. Adjusting the relative
position is sometimes necessary before
tightening or loosening the handle in tight
locations.
NOTICE
DO NOT over-tighten screws or bolts into
the cast iron. Cast iron threads strip more
easily than steel.
Figure 22. Fence mount lock handle.
Fence Positioning
The two fence faces are independently
adjustable to allow for different shaping tasks.
The fence faces can be set at different positions
to remove material from the entire edge of the
wood stock or the same position to allow the
shaping of part of the edge.
To adjust the fence, do these steps:
1. Loosen the fence mount lock handle located
on the side of the fence mount shown in
Figure 22.
2. Adjust the position of the fence by turning
the adjustment knob located on the back of
the fence mount shown in Figure 22.
3. Once the fence is in the desired position,
tighten down the fence mount lock handle.
ADJUSTMENTS
KEEP loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Adjustment
Knob
Fence Mount
Lock Handle
UNPLUG the power
cord before you do any
assembly, adjustments,
or maintenance tasks!
Otherwise, serious
personal injury to you
or others may occur!
WEAR your safety goggles
during any machine
assembly, operation, or
maintenance. Failure to
comply may result in
serious personal injury.