Filter
Top Products
-32-
MAINTENANCE
Lubrication
Since all bearings are shielded and permanently
lubricated, simply leave them alone until they
need to be replaced. Do not lubricate them.
For other items on this machine, an occasional
application of light machine oil is all that is
necessary. Before applying lubricant, clean off
sawdust.
Your goal is to achieve adequate lubrication.
Too much lubrication will attract dirt and
sawdust. Various parts of your machine could
lose their freedom of movement as a result.
Regular periodic maintenance on your Model
W1702 Shaper will ensure its optimum
performance. Make a habit of inspecting your
shaper each time you use it. Check for the
following conditions and repair or replace parts
when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged drive belt.
5. Any other condition that could hamper the
safe operation of this machine.
General
Table and Base
The table can be kept rust-free with regular
applications of products like Boeshield
®
T-9. For
long term storage you may want to consider
products like Kleen Bore's Rust Guardit™.
MAINTENANCE
KEEP loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
UNPLUG the power
cord before you do any
assembly, adjustments,
or maintenance tasks!
Otherwise, serious
personal injury to you
or others may occur!
WEAR your safety glasses
and dust mask during any
machine operation or
maintenance. Failure to
comply may result in
serious personal injury.