Filter
Top Products
-22-
OPERATIONS
Start Up
Once assembly is complete and adjustments
have been made, the shaper is ready for start
up. Always pay attention to any unusual noises
and vibrations on every start up, as well as
make sure the shaper operates as intended.
1.
MAKE SURE that the fence, any accessories,
Jigs, spindle, cutter, or router bit adapter
being used is tight and no loose items are on
the table.
2. Put your safety glasses on, and start the
shaper by turning the switch to the forward
position. Be sure to have your finger poised
to stop the machine if there is a problem.
3. Once the machine is running, listen for any
unusual noises coming from the shaper. The
shaper should run smoothly with little or no
vibrations.
• If there is an unusual noise or vibration,
shut the machine off immediately. DO NOT
run the shaper any further until the
problems are corrected. Refer to the
Troubleshooting section on Page 33 for
possible causes and solutions.
• If the problem continues and cannot be
easily identified, contact our customer
service department.
OPERATIONS
KEEP loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
UNPLUG the power
cord before you do any
assembly, adjustments,
or maintenance tasks!
Otherwise, serious
personal injury to you
or others may occur!
WEAR your safety glasses
and dust mask during
machine operation.
Failure to comply may
result in serious personal
injury.