Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 67450
Turn on the air compressor according to 6.
the manufacturer’s directions and allow it
to build up pressure until it cycles off.
Adjust the air compressor’s output
7.
regulator so that the air output is enough
to properly power the tool, but the output
will not exceed the tool’s maximum
air pressure at any time. Adjust the
pressure gradually, while checking the
air output gauge for the right pressure
range.
The air pressure setting must not exceed
8.
job site regulations/restrictions. The air
pressure setting must not exceed 90 PSI
when being used with work pieces that
have a thickness of less than 1-3/4”.
Inspect the air connections for leaks. 9.
Repair any leaks found.
If the tool will not be used at this time, 10.
turn off and detach the air supply, safely
discharge any residual air pressure, and
release the trigger to prevent accidental
operation.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion after
disconnecting to ensure that the tool is
disconnected and unpowered.