Filter
Top Products
Page 14 For technical questions, please call 1-800-444-3353. SKU 67450
(88). The Platform can be adjusted up
and down to use various lengths of nails
from
3
/
4
” to 1-
3
/
4
”:
A. Between 3/4” and 1” Long
Nails
(Use top setting).
B. Between 1” and 1-1/4” Long
Nails
(Use middle setting).
C. Between 1-1/4” and 1-3/4”
Long Nails
(Use bottom setting).
Latch (68)
Catch
(64)
Canister
Cover
(89)
Canister
(82)
Canister
Cover
(89)
Adjuster Plate
(86)
Canister
(82)
Feed
Hook
(50)
Nails
3. Turn the Adjuster Nut (88) clockwise
to raise the Adjuster Plate (86) until its
edge aligns with the embossed nail
size markings on the inside wall of the
Canister.
Place a coil of Nails around the Adjuster 4.
Plate (86) in the Nail Canister (82). See
photo, above.
Swing the Canister Cover (89) closed. 5.
Then, close the Catch (64). Make sure
the Latch closes securely. If it does not
engage, the nail head is not in the slot in
the upper portion of the Feed Hook (50)
and nail shank is not in the feeder.
BOTTOM VIEW
Screw
(80)
Bracket
(79)
SHINGLE SPACING
6. To adjust the Shingle Bracket: The
Bracket (79) controls roof shingle
spacing. To adjust the Bracket to work
with a particular width of shingles, use
the accessory Hex Wrench to loosen the
Screw (80) on the Bracket. Slide the
Bracket to the desired spacing. Then,
retighten the Screw.
General Operating Instructions
Before each use, test the Tool as 1.
directed in the earlier section.
If an automatic oiler is not used, 2. add
a few drops of Pneumatic Tool Oil into
the tool’s airline connection before use.
Add a few drops more after each hour of
continual use.
Keep all moving parts free from dirt, tar, 3.
and debris. Clean and oil all moving
parts before each use.
Attach the Nailer to the air supply at the 4.
Air Inlet (93). Start your compressor and
check the pressure, making sure it is set
REV 10d