Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.SKU 67450
using the tool that the air source has
been adjusted to the rated air pressure
or within the rated air-pressure range.
Never use oxygen, carbon dioxide,
b.
combustible gases or any bottled gas
as an air source for the tool. Such
gases are capable of explosion and
serious injury to persons.
SAVE THESE
INSTRUCTIONS.
SPECIFIC SAFETY
INSTRUCTIONS
Operators and others in work area 1.
MUST wear ANSI-approved safety
goggles with side shields during use.
The employer is responsible to enforce
the use of eye protection by the operator
and others in the work area.
Keep ngers away from trigger 2.
when not driving fasteners to avoid
accidental ring.
Choice of triggering method is 3.
important. Check manual for
triggering options.
Always assume the tool contains 4.
fasteners.
Do not point the tool toward yourself or 5.
anyone whether it contains fasteners or
not.
Do not actuate the tool unless the tool is
6.
Respect the tool as a working implement.7.
No horseplay. This tool is not a toy and 8.
can be deadly if misused.
Do not load the tool with fasteners when 9.
any one of the operating controls, such
as the Trigger or Safety Nosepiece, is
activated.
Do not remove, tamper with, or otherwise 10.
cause the tool operating controls to
become inoperable.
Do not operate the tool if any portion of 11.
the tool operating controls is inoperable,
disconnected, altered, or not working
properly.
Disconnect the tool from the air supply
12.
when:
Unattended.
a.
Performing any maintenance or repair.b.
Clearing a jam.c.
Moving the tool to a new location.d.
13.
tool.
Refer to the tool maintenance 14.
instructions for detailed information on
the proper maintenance of the tool.
Fire fasteners into an appropriate 15.
work surface only. Do not attempt to
penetrate. Do not drive fasteners on top
of other fasteners, or at too steep of an
angle. Fasteners can ricochet causing
personal injury.
16.
edge of a workpiece. They may split the
injury.
Keep clear of the workpiece near the
17.
area being fastened. Fasteners may
them to exit the workpiece at an
unexpected point, causing personal
injury.
Transport tool safely. Always disconnect 18.
air supply when moving the tool. Carry