Filter
Top Products
Page 4 For technical questions, please call 1-800-444-3353. SKU 67450
WARNING – Do not re fastener on j.
top of another fastener. This is able to
hit someone, or cause the tool to react
and result in a risk of injury to persons.
WARNING – Remove nger from the
k.
trigger when not driving fasteners.
Never carry the
Tool use and care
Use clamps or another practical way a.
to secure and support the workpiece
to a stable platform. Holding the work
by hand or against the body is unstable
and can lead to loss of control.
Do not force the tool.b. Use the correct
tool for the application. The correct tool
will do the job better and safer at the rate
for which the tool is designed.
Do not use the tool if the trigger does c.
not turn the tool on or off. Any tool that
cannot be controlled with the trigger is
dangerous and must not be used until
repaired.
Disconnect the tool from the air d.
source before making adjustments,
doing tool maintenance, clearing
jams, touching the safety nosepiece,
leaving work area, loading, or
unloading the tool. Such precautionary
measures reduce the risk of injury to
persons.
Store the tool when it is idle out of e.
reach of children and other untrained
persons. A tool is dangerous in the
hands of untrained users.
Maintain the tool with care.f. A properly
maintained tool reduces the risk of
binding and is easier to control.
Check for misalignment or binding g.
of moving parts, breakage of parts,
and any other condition that affects
the tool’s operation. If damaged,
have the tool serviced before using.
Many accidents are caused by poorly
maintained tools. There is a risk of
bursting if the tool is damaged.
Use only accessories that are h.
identied by the manufacturer for
the specic tool model. Use of an
accessory not intended for use with the
injury to persons.
Use only those fasteners listed in the i.
Specications chart of this manual.
Fasteners
tool by the tool manufacturer are able to
result in a risk of injury to persons or tool
damage when used in this tool.
Service
Tool service must be performed only a.
by qualied repair personnel.
When servicing a tool, use only b.
identical replacement parts. Use only
authorized parts.
Use only the lubricants supplied c.
with the tool or specied by the
manufacturer.
Air source
a. Never connect to an air
source that is capable of
exceeding 200 PSI. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury to
persons. Use only clean, dry, regulated
compressed air at the rated pressure or
within the rated pressure range as
marked on the tool. Always verify prior to