Harbor Freight Tools 67847 Air Compressor User Manual


 
Page 5For technical questions, please call 1-800-444-3353.SKU 67847
Service5.
Have your compressor serviced a.
by a qualied repair person using
only identical replacement parts.
This will ensure that the safety of the
compressor is maintained.
Air Compressor Safety Warnings
Risk of re or explosion - Do not 1.
spray ammable liquid in a conned
area or towards a hot surface. Spray
area must be well-ventilated. Do not
smoke while spraying or spray where
spark or ame is present. Arcing
parts - Keep compressor at least 20
feet away from explosive vapors,
such as when spraying with a spray
gun.
Risk of bursting - Do not adjust 2.
regulator higher than maximum
stated pressure of attachment.
Risk of injury - Do not direct air 3.
stream at people or animals.
To reduce the risk of electric shock, 4.
do not expose to rain. Store indoors.
Wear ANSI-approved safety goggles 5.
during use.
Do not use to supply breathing air. 6.
Do not use the air hose to move the 7.
compressor.
Drain Tank daily and after use. 8.
Internal rust causes tank failure and
explosion.
Add correct amount of compressor 9.
oil before rst use and every
use. Operating with the incorrect
amount of oil causes permanent
damage and voids warranty. To
prevent damage, do not use with
overlled or low oil. Slowly ll to
full line, wait 2 minutes and ll
back up to full line. Compressor
has small passages that will ll
slowly.
Do not remove the Pressure Switch 10.
(54) cover or adjust the internal
components.
Do not use the air hose to move the 11.
compressor.
Compressor head gets hot during 12.
operation. Do not touch it or allow
children nearby during or immediately
following operation.
Release the pressure in the storage 13.
tank before moving.
The use of accessories or 14.
attachments not recommended by
the manufacturer may result in a risk
of injury to persons.
All air line components, including 15.
hoses, pipe, connectors, lters, etc.,
must be rated for a minimum working
pressure of 125 PSI, or 150% of
the maximum system pressure,
whichever is greater.
USE OF AN EXTENSION CORD 16.
IS NOT RECOMMENDED. If you
choose to use an extension cord, use
the following guidelines:
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’ 50’ 100’ 150’
0 – 6 18 16 16 14
6.1 – 10 18 16 14 12
TABLE A