Filter
Top Products
SKU 91146 For technical questions, please call 1-800-444-3353. PAGE 14
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 26 and 28.
To Attach A Power Cord Plug:
1. WARNING! Only a qualified, certified electrician should attach a 220
volt Power Plug (not included) to the Power Cord of the Welder.
2. For further instructions, refer to page 5 and page 6 of this manual.
To Attach The Rear Wheels And Front Castor Wheels:
1. WARNING! Prior to performing any further assembly procedures,
make sure the Power Cord Plug of the Welder is unplugged from its
electrical outlet.
2. To attach the two Rear Wheels (47) to the Welder, slide a Wheel onto each end
of the Axle located at the rear of the Base (19). Secure both Wheels to the Axle by
inserting one Cotter Pin through each end of the Axle. Once inserted, make sure
to spread each Cotter Pin to keep them in place. (See Figure G.)
3. To attach the two Front Castor Wheels (48) to the Welder, align the four holes in
each top plate of a Castor Wheel with the four
threaded
mounting holes located
in each corner at the bottom/front of the Welder. Use four Bolts (45) and four
Washers (46) to secure each Castor Wheel to the Base. (See Figure G.)
FIGURE G
BASE (19)
REAR WHEEL (47)
AXLE
COTTER PIN (44)
WASHER (46)
BOLT (45)
FRONT
CASTOR WHEEL (48)