Filter
Top Products
SKU 91146 For technical questions, please call 1-800-444-3353. PAGE 6
220 VOLT
POWER PLUG
(NOT INCLUDED)
220 VOLT
ELECTRICAL OUTLET
(NOT INCLUDED)
WARNING!
ONLY A QUALIFIED, CERTIFIED
ELECTRICIAN SHOULD CONNECT A
POWER PLUG TO THE POWER CORD.
POWER CORD
FIGURE A
Improperly connecting the grounding wire can result in the risk of electric shock.
Check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded. Do not modify the power cord plug provided with the tool.
Never remove the grounding prong from the plug. Do not use the tool if the power
cord or plug is damaged. If damaged, have it repaired by a service facility before
use. If the plug will not fit the outlet, have a proper outlet installed by a qualified
electrician.
GROUNDED EQUIPMENT: EQUIPMENT WITH THREE PRONG PLUGS
1. WARNING! The Power Cord requires the attachment of a 220 volt,
grounded, 3-Prong Plug (not included). For safety purposes, only a qualified,
certified, electrician should attach a Plug to the Power Cord. Never modify the
Plug in any way. To comply with the National Electric Code, and to provide
additional protection from the risk of electrical shock, this product should only be
connected to a 220 volt electrical outlet that is protected by a Ground Fault Circuit
Interrupter (GFCI).
2. The grounding prong in the plug is connected to the green wire inside the cord to
the grounding system in the welding equipment. The green wire in the cord must
be the only wire connected to the equipment’s grounding system and must never
be attached to an electrically “live” terminal. (See Figure A.)
3. Your welding equipment must be plugged into an appropriate outlet, properly
installed and grounded in accordance with all codes and ordinances. The plug
and outlet should look like those in the following illustration. (See Figure A.)
GROUNDING
WARNING!