Filter
Top Products
2ą307-586
WARNING
INJECTION HAZARD
Spray
from the gun, hose leaks, or ruptured components can inject fluid into your body and cause an
extremely serious injury
, including the need for amputation. Splashing fluid in the eyes or on the skin
can also cause a serious injury
.
D
Fluid injected into the skin might look like just a cut, but
it is a serious injury
.
Get immediate medi
-
cal attention.
D
Do not point the spray gun at anyone or at any part of the body
.
D
Do not put hand or fingers over the spray tip.
D
Do not stop or deflect fluid leaks with your hand, body
, glove, or rag.
D
Do not “blow back” fluid; this is not an air spray gun.
D
Check the gun dif
fuser operation weekly
.
D
Be sure the gun trigger safety operates before spraying.
D
Lock the gun trigger safety when you stop spraying.
D
Follow the
Pressure Relief Procedure
on page 7 whenever you: are instructed to relieve pres
-
sure; stop spraying; clean, check, or service the equipment; or install or clean the spray tip.
D T
ighten all the fluid connections before operating the equipment.
D
Check the hoses, tubes, and couplings daily
. Replace worn, damaged, or loose parts immediately
.
Permanently coupled hoses cannot be repaired; replace the entire hose.
FIRE AND EXPLOSION HAZARD
Improper
grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury
.
D
Ground the equipment and the object being sprayed. See
Ground the System
on page 6.
D
Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or the fluid being
sprayed.
D
Extinguish all the open flames or pilot lights in the spray area.
D
Electrically disconnect all the equipment in the spray area.
D
Keep the spray area free of debris, including solvent, rags, and gasoline.
D
Do not turn on or of
f any light switch in the spray area while operating or if fumes are present.
D
Do not smoke in the spray area.
D
Do not operate a gasoline engine in the spray area.
D
If there is any static sparking while using the equipment,
stop spraying immediately
. Identify and
correct the problem.