Filter
Top Products
14
7. Securing the workpiece
WARNING: Always clamp or vise to secure the workpiece to the fence; otherwise
the workpiece might be thrust from the table and cause bodily harm.
8. Installing the holders ... (Optional accessory)
The holders help keep longer workpieces stable
and in place during the cutting operation.
(1) As indicated in Fig. 13, use a steel square for
aligning the upper edge of the holders with the
base surface.
Loosen the 6mm wing nut. Turn a height
adjustment bolt 6mm, and adjust the height
of the holder.
(2) After adjustment, firmly tighten the wing nut
and fasten the holder with the 6mm knob bolt
(optional accessory). If the length of Height
Adjustment Bolt 6mm is insufficient, spread a
thin plate beneath. Make sure the end of Height
Adjustment Bolt 6mm does not protrude from
the holder.
9. Stopper for precision cutting ... (Stopper and holder are optional accessory)
The stopper facilitates continuous precision cutting
in lengths of 280mm to 450mm (11" to 17-3/4").
To install the stopper, attach it to the holder with
the 6mm knob bolt as shown in Fig. 14.
Fig. 14
6mm Knob Bolt
(Optional accessory)
Holder
(Optional
accessory)
Steel Square
Base Surface
6mm Wing
Nut
(Optional
accessory)
Height Adjustment
Bolt 6mm
(Optional accessory)
Workpiece
Stopper
(Optional accessory)
6mm Knob Bolt
(Optional accessory)
Holder
(Optional accessory)
Move
6mm Wing Nut
(Optional accessory)
Height
Adjustment Bolt
6mm (Optional
accessory)
Fig. 13
01Eng_C10FSH_Eng 3/29/07, 12:30 PM14