Filter
Top Products
15
10. Confirmation for use of sub fence (A)…(Optional accessory)
WARNING: In the case of right bevel cutting, remove the sub fence (A). Supposing
it is not able to remove it, It will contact the blade or some part of the
tool, causing in serious injury to operator.
In the case of direct angle cutting and angle cutting,
use the sub fence (A). The sub fence (A) can be
installed on the right side of the guide fence. Insert
the rods of the sub fence (A) into the holes in the
guide fence. Tighten the 6mm knob bolt which
come with the sub fence (A) to secure the sub fence
(A). Then, you can realize stable cutting of the
material with a wide back face.
11. Using an ink line
(1) Right angle cutting
Loosen the 6mm knob bolt and contact the tip
of the guard with the workpiece.
Aligning the ink line on the workpiece with the
groove of the guard, the workpiece is cut on
the ink line (Fig. 16).
(2) Miter cutting and compound cutting
(Miter cutting + bevel cutting)
Upon lowering the motor section, the lower
guard is raised and the saw blade appears.
Align the ink line with the saw blade (Fig. 17).
CAUTION: In some arrangements when the turntable is rotated, the guard projects
from the fence surface. Loosen the 6mm knob bolt and push the guard to
the retracted position. Never lift the lower guard while the saw blade is
rotating. When cutting at an angle of 35° to the right or more, please
slide the guard to the rear.
The guard and sub-fence will not only make contact and adversely affect
cutting accuracy, this could also result in damage to the guard.
Sub Fence (A)
6mm
Knob Bolt
Fig. 15
Marking
(pre-marked)
Workpiece
Guard
Saw Blade Groove
6mm
Knob Bolt
Marking
(pre-marked)
6mm Knob Bolt
Lower Guard
Move the
Guard
Backward
Fence (B)
Fig. 17
Fig. 16
01Eng_C10FSH_Eng 3/29/07, 12:30 PM15