Filter
Top Products
20
* Every time one cutting or deep-cutting operation is finished, turn
the switch off, and check that the saw blade has stopped. Then raise
the handle, and return it to the full retract position.
* Be absolutely sure to remove the cut material from the top of the
turntable, and then proceed to the next step.
* Continued cutting operation can result in overload of the motor.
Touch the motor and if it's hot, stop your cutting operation once and
rest for 10 minutes or so, and then restart your cutting operation.
4. Cutting narrow workpieces (Press cutting)
Slide the hinge down to holder (A), then tighten
the slide securing knob (see Fig. 2) as indicated in
Fig. 27.
Lower the handle to cut the workpiece.
Using the power tool this way will permit cutting
of workpieces of up to 88mm (3-15/32") square.
5. Cutting large workpieces
There may be case when a complete cutting cannot
be done depending on the height of workpiece. In
this case, mount an auxiliary board with the 6mm
flat head screws and the 6mm nuts using the 7mm
holes on the fence surface (two holes on each side).
(Fig. 28)
Refer to page 6 "SPECIFICATIONS" for the thickness
of the auxiliary board.
6. Cutting wide workpieces (Slide cutting)
(1) Workpieces up to 88mm (3-15/32") high and
312mm (12-9/32") wide:
Loosen the slide securing knob (see Fig. 2), grip
the handle and slide the saw blade forward.
Then press down on the handle and slide the
saw blade back to cut the workpiece as
indicated in Fig. 29. This facilitates cutting of
workpieces of up to 88mm (3-15/32") in height
and 312mm (12-9/32") in width.
(2)
Workpieces up to 91mm (3-19/32") high and
300mm (11-13/16") wide:
Workpieces of up to 91mm (3-19/32") in height
and up to 300mm (11-13/16") in width can be
cut in the same manner as described in
paragraph 6-(1) above.
Hinge
Holder (A)
Handle
Press
Down
Workpiece
Fence
6mm Nut
6mm Flad
Hd. Screw
Auxiliary
Board
Fig. 29
Fig. 28
Fig. 27
Handle
2 Press
Down
Workpiece
1 Pull Forward
3 Push Rearward to Cut
▲
▲
01Eng_C10FSH_Eng 3/29/07, 12:30 PM20