Filter
Top Products
20
English
Miter Gauge
Approx. 1/8"
(3.2 mm)
6. Miter Gauge Operation
The miter gauge can be used on either side of the miter gauge
grooves on the table. However, for bevel cutting (the saw blade
is tilted), use the miter gauge in the right side miter gauge groove
to prevent hands or miter gauge from interfering with the saw
blade guard. Miter gauge is accurately adjustable at 90° and 45°
right and left in relation to the saw blade.
Intentional miter cut angle can be otbained easily.
(1) Loosen clamp handle (B).
(2) Turning the miter gauge to the desired angle.
(3) Tighten clamp handle (B) to lock the miter gauge.
WARNINGS ON OPERATION
For your own safety carefully read and observe the following warnings and precautions in addition to the
[IMPORTANT INFORMATION], [SAFETY] and [WARNING]
1. The saw blade is firmly locked.
2. Never perform any operation “free hand” without using the miter gauge, rip fence, and or other auxiliary
devices. To do so could cause accidents from kickback should the saw blade become locked in the
workpiece material.
3. When miter gauge is used, remove rip fence from table.
4. When the miter gauge is used, securely tighten clamp handle (B).
5. When rip fence is used, remove miter gauge from table.
6. When the rip fence is used, securely lock the grip.
7. If blade stalls or stops, TURN SWITCH OFF before releasing blade.
8. Never remove small cut-off pieces with your fingers. Remove them by pushing them clear with a long
stick.
9. Never attempt to remove small cut-off pieces trapped inside the saw blade guard while the saw is
running. Turn the switch “OFF”, allow the saw blade to come to a complete stop, raise the saw blade
guard, and remove the cut-offs.
10. Adjust the saw blade height so it is about 1/8" (3.2 mm) above the top of the workpiece. More exposure
would be hazardous (see Fig. 24).
11. Never touch any cut-offs while saw blade is running.
12. Feed material slowly in order to make fine cut, keep accuracy,
and avoid overloading.
OPERATING INSTRUCTIONS
There are two basic types of cuts. Ripping and cross cutting. In general, cutting with the grain is ripping and
across the gain is cross cutting. Neither ripping or cross cutting may be done safely freehand. Ripping
requires the use of the rip fence and cross cutting uses the miter gauge. Safety glasses are being worn.
ALWAYS USE EYE PROTECTION WHEN WORKING WITH THE TOOL TO PREVENT EYE INJURY.
Ordinary eyeglasses do not provide adequate protection since the lenses are not made of safety glass. Also,
use a face mask for additional safety and wear a dust mask if the cutting operation produces dust.
Fig. 23
Clamp
Handle (B)
Blade Guard
Miter Gauge
Groove
Fig. 24
Workpiece
Saw Blade