Filter
Top Products
14 - 4
Charge Battery
With the battery inside the battery charge
sleeve, place the battery charge sleeve into
the base with the battery contacts going in
first and facing up.
Troubleshooting the Base
Note: Please visit the Services and Support section of our website
(www.honeywell.com/aidc) to check for the latest software for both the
image scanner and the base.
If your base is not functioning properly, review the following troubleshooting
guidelines to try to isolate the problem.
Is the red LED on?
If the red LED isn’t illuminated, check that:
• The power cable is connected properly and there is power at the power
source.
• The host system power is on (if external power isn’t used).
Is the green LED on?
If the
green
LED isn’t illuminated, check that:
• The image scanner is correctly placed in the base.
• There is external power or 12 volt host power.
• Charge mode is turned on. (See "Base Charge Mode" on page 3-3)
• The battery is not bad or deeply discharged. In some cases, the image
scanner’s battery may trickle charge to bring it into an acceptable level and
then transition to a normal charge cycle.
Troubleshooting the Image Scanner
Note: Make sure that your image scanner’s battery is charged.
Please visit the Services and Support section of our website
(www.honeywell.com/aidc) to check for the latest software for both the
image scanner and the base.
Is the image scanner having trouble reading your symbols?
If the image scanner isn’t reading symbols well, check that the symbols: