Filter
Top Products
2 - 6
CTS/RTS Emulation
ACK/NAK Mode
Serial Wedge
To set up the serial wedge terminal ID, use the serial terminal ID 050 and follow
the instructions on page 2-6. Make sure that all of the communication parame-
ters match on all of the connected devices. Scanning Both P1 and P2 sends
scanned data to P1 and P2. Default = P1.
Programming the Interface - Terminal ID Method
If your interface is not a standard PC AT, refer to Supported Terminals, begin-
ning on page 2-8, and locate the Terminal ID number for your PC. Scan the
Terminal ID bar code below, then scan the numeric bar code(s) from the
Programming Chart inside the back cover of this manual to program the image
scanner for your terminal ID. Scan Save to save your selection.
CTS/RTS Emulation On
* CTS/RTS Emulation Off
ACK/NAK Mode On
* ACK/NAK Mode Off
* P1
P2
Both P1 and P2