Filter
Top Products
10
STORAGE
1. Short Term
If the hammer will not be used for periods of one week or more, the tool should be removed from
the hammer and grease must be applied to the piston bottom. The hammer should be stored
indoors standing vertically in the working position.
2. Long Term
For storage of more than 2 - 3 weeks or where condensation or corrosion is prevalent
(salt-water areas) note the following instructions. Remove and clean the tool. Flush the
front cap with clean solvent or hydraulic oil. Coat the exposed portion of the piston with
grease, apply grease to the tool and re-install. Store the hammer vertically and away
from standing moisture. To start the hammer after long-term storage, remove the tool
and inspect the exposed portion of the piston for corrosion. If corrosion is found do not
use the hammer until the defective piston has been repaired or replaced.
TOOL REPLACEMENT
Table 1. Standard Tool Weights
TOOL WEIGHTS Kg lbs.
HH1500 45 99
HH2000 74 162
HH3600 118 260
HH4500 152 334
HH5800 174 381
HH8000 214 470